DataCard SR200 Service Manual page 36

2
>Push
Parameter settings save in the head EEP-ROM.
* The buzzer beeps in case of an error.
[NEXT]
Loading the parameter settings from the head EEP-ROM.
>Pop
* If the correct data is not stored by the head EEP-ROM,
"No Data" is displayed and the buzzer beeps.
[NEXT]
[ENTER]
>Laminator> >>Maintenance>
[EXIT]
>>Information>
[ENTER]
>>>Offset Card X
[EXIT]
[NEXT] [NEXT]
>>>Mk Snsr T Lvl
[NEXT]
>>>Mk Snsr B Lvl
[NEXT]
>>>EndSnsr T Lvl
[NEXT]
>>>EndSnsr B Lvl
[ENTER]
>>>Firmware
[EXIT]
[NEXT]
>>>Total Count
[NEXT]
>>>HR-T Temp
[NEXT]
>>>HR-B Temp
[NEXT]
>>>HR-T POT
[NEXT]
>>>HR-B POT
[NEXT]
>>>HR-T POT Rst
[NEXT]
>>>HR-B POT Rst
Setting of the card stop position X
[-7(Left) --- -1(Left),0,+1(Right) --- +7(Right)]
Select with [ ][ ] and save with [ENTER].
Adjust the threshold level of the Marker Sensor T
[1 --- 10]
Select with [ ][ ] and save with [ENTER].
Adjust the threshold level of the Marker Sensor B
[1 --- 10]
Select with [ ][ ] and save with [ENTER].
Adjust the threshold level of the End Sensor T
[1 --- 10]
Select with [ ][ ] and save with [ENTER].
Adjust the threshold level of the End Sensor B
[1 --- 10]
Select with [ ][ ] and save with [ENTER].
Laminator Firmware version
Laminator Total Counter
Laminator Heater-T Temperature
Laminator Heater-B Temperature
Laminator Heater-T Power on time
Laminator Heater-B Power on time
Laminator Heater-T Power on time Reset
Laminator Heater-B Power on time Reset
(No.HD007<Rev.001>)1-35