DataCard SR200 Service Manual page 30

(4) Set the ink ribbon, and turn the take-up side until the cut
section is out of sight.
• Install while referring to the indication on the label of
the cassette.
a) With the inked surface facing outward, align the
yellow side of the unused ribbon with the arrow on
the cassette, and unwind it along the three shafts.
b) Turn the knob in the direction of the arrow to re-
move any slack.
c) Insert the ink ribbon firmly into the bobbin holders
with the ribbon set to the far end of the guides.
(5) Insert the cassette all the way in along the guide rail until
a "click" sound is heard. Close the door.
(6) Press [RESET] →
to initialize the printer.
5.1.11 Door Open
Printer door is open. Close the door. Or, the cleaning roller is not
attached. Attach the cleaning roller.
Door Open
5.1.12 Film Run Out
Retransfer film has run out. Replace with a new one.
Film Run Out
Note:
• Stand the cassette on a flat surface as illustrated in the dia-
gram. Avoid doing so on a floor as dust attached to the
retransfer film may cause printing errors.
• Do not touch the retransfer face (the side that faces outward
when installed) with your hand. Touching it may cause print-
ing errors. Put on the supplied gloves when handling the
retransfer film.
• When handling the cassette, hold it with both hands. Acci-
dentally dropping the cassette may damage it or result in in-
juries.
• When installing a used retransfer film, align the unused side
of the film with the arrow indicated on the label of the cas-
sette. Failure to do so may result in errors, or the print may
turn out light.
• When installing a new film, make sure that at least three
black lines are wound onto the take-up side. Insufficient
winding may cause the printer to malfunction.
• Do not perform work on the printer door. Do not place heavy
objects or apply load on the printer. Doing so may damage it.
• During replacement, clean the four bobbin holders on the
printer. Burrs generated by friction between the bobbins and
bobbin holders may be adhered to the ink ribbon or
retransfer film, causing printing errors.
(1) Open the printer door.
D1
A2
(No.HD007<Rev.001>)1-29