DataCard SR200 Service Manual page 11

(3) Close back the MAIN Board to its original position, and fix
the MAIN Board with the four screws.
Securely hook the two brackets, fixing the
MAIN Board, to the frame of the main unit.
Screw :
QYSDST3006NA x 4
A
B
View A
The cam gear and the wire should be parted.
Organize the head wire so that it does not
touch the rotating parts such as belts/gears,
and then fix the head wire with the wire clamp.
Make sure that the wires do not touch the encoder.
View B
Opened MAIN Board
1-10 (No.HD007<Rev.001>)
MAIN Board
Coaxial connector
Make sure that the coaxial
connector is not loose.
Allow about 5 mm slack to
enable the cable to move.
(4) Connect the wires from the MG unit and the turn unit follow-
ing the drawing below.
Connect the MG unit and the board bracket, and fix them with screws.
Wire : QUB030-05HMHM-E
Screw : QYSDST3006NA x 2
MG UNIT
MAIN Board
MG unit accessories
MG Unit
MAIN Board MAIN Board MAIN Board
CN15 CN19
2.2.5 Attaching the IC R/W unit
Note:
After mounting the IC R/W unit, be sure to check the rele-
vant item referring to "2.3 Check details after mounting
separately sold parts".
(1) Attach the IC R/W unit to the plate.
Wire from the turn unit CN1
Run the wires from the turn
unit and the MG unit together
through this wire clamp, and
fix them.
CN19
CN15
Wire from the
turn unit CN1
Wire clamp
QYSPSPH3006NA x 3
IC R/W Unit
QZW0326-002 x 3