DataCard SR200 Service Manual page 33

5.1.18 HR Overheat
The temperture of the warpage correction heating roller or
retransfer heating roller is too high. Turn off and on the power.
If the same problem recurs, turn off the power and consult our
authorized dealers.
HR Overheat
5.1.19 Hardware
A hardware error has occurred during initialization. Turn off and
on the power. If the same problem recurs, turn off the power and
consult our authorized dealers.
Hardware
5.1.20 TR Overheat
The temperature of the retransfer roller is too high. Turn off and
on the power. If the same problem recurs, turn off the power and
consult our authorized dealers.
TR Overheat
5.1.21 TR heater
Retransfer roller failure. Turn off and on the power. If the same
problem recurs, turn off the power and consult our authorized
dealers.
TR heater
5.1.22 TR Thermister
Retransfer roller thermister failure. Turn off and on the power.
If the same problem recurs, turn off the power and consult our
authorized dealers.
TR Thermister
5.1.23 RR Overheat
The temperature of the warpage correction roller is too high.
Turn off and on the power. If the same problem recurs, turn off
the power and consult our authorized dealers.
RR Overheat
5.1.24 RR Heater
Warpage correction roller failure. Turn off and on the power.
If the same problem recurs, turn off the power and consult our
authorized dealers.
RR Heater
1-32 (No.HD007<Rev.001>)
5.1.25 RR Thermister
Warpage correction roller thermister failure. Turn off and on the
power. If the same problem recurs, turn off the power and consult
our authorized dealers.
C2
5.1.26 Overcool
The operating ambient temperature of the printer is too low.
Check the temperature. If the same problem recurs at the same
operating ambient temperature, turn off the power and consult
our authorized dealers.
D8
5.1.27 Head Overheat
The temperature of the thermal head is too high. Turn off and on
the power. If the same problem recurs, turn off the power and
consult our authorized dealers.
F0
5.1.28 Power Int.
A 24 V interruption is detected.
Turn off and on the power again.
F1
F2
F3
F4
RR Thermister
Overcool
Head Overheat
Power Int.
F5
F6
F8
C3