DataCard SR200 Service Manual page 32

(1) Open the printer door.
(2) Press and hold down the cassette button, and pull out the
cassette (on the right) to remove the ink ribbon.
(3) Install a new ink ribbon.
Install while referring to the indication on the label of the
cassette.
a) With the inked surface facing outward, align the yel-
low side of the unused ribbon with the arrow on the
cassette, and unwind it along the three shafts.
b) Insert the ink ribbon firmly into the bobbin holders
with the ribbon set to the far end of the guides.
A: take-up side (black)
B: unused side (yellow)
(4) Remove any slack in the ink ribbon.
a) Hold the cassette.
b) Turn the knob in the direction indicated by the arrow.
(5) Insert the cassette all the way in along the guide rail until a
"click" sound is heard. Close the door.
(6) Press [RESET] →
5.1.14 Hard ware
A hardware failure has occurred on the printer. Turn off and on
the power. If the same problem recurs, turn off the power and
consult our authorized dealers.
Hard ware
5.1.15 MG Mechanical
An error has occurred in the mechanical component of the MG
unit. Turn off and on the power. If the same problem recurs, turn
off the power and consult our authorized dealers.
MG Mechanical
5.1.16 MG Hardware
A hardware failure has occurred on the MG unit. Turn off and on
the power. If the same problem recurs, turn off the power and
consult our authorized dealers.
MG Hardware
5.1.17 Cam Error
Heating roller operation failure. Turn off and on the power. If the
same problem recurs, turn off the power and consult our autho-
rized dealers.
Cam Error
to initialize the printer.
44
AB
AC
C1
(No.HD007<Rev.001>)1-31