DataCard SR200 Service Manual page 31

(2) Press and hold down the cassette button, and pull out
the cassette (on the left) to remove the retransfer film.
(3) Install a new retransfer film.
Install while referring to the indication on the label of the
cassette.
a) When installing the retransfer film, make sure that
at least three black lines are wound onto the take-
up side.
b) With the retransfer face facing outward, align the
unused side of the film with the arrow on the cas-
sette, and unwind it along the three shafts.
c) Insert the retransfer film firmly into the bobbin hold-
ers with the film set to the far end of the guides.
A: take-up side (black)
B: unused side (green)
(4) Remove any slack in the film.
a) Hold the retransfer film cassette.
b) Turn the knob in the direction indicated by the ar-
row.
(5) Insert the cassette all the way in along the guide rail until
a "click" sound is heard. Close the door.
1-30 (No.HD007<Rev.001>)
(6) Press [RESET] →
5.1.13 Ink Run Out
Ink ribbon has run out. Replace with a new one.
Ink Run Out
Note:
• Stand the cassette on a flat surface as illustrated in the dia-
gram. Avoid doing so on a floor as dust attached to the
retransfer film may cause printing errors.
• Do not touch the inked surface (the side that faces outward
when installed) with your hand. Touching it may cause print-
ing errors. Put on the supplied gloves when handling the ink
ribbon.
• When handling the cassette, hold it with both hands. Acci-
dentally dropping the cassette may damage it or result in in-
juries.
• When installing a used ink ribbon, align the yellow side of the
unused ribbon with the arrow indicated on the label of the
cassette. If the position of the yellow side is not properly
aligned, the print may turn out light.
• Do not perform work on the printer door. Do not place heavy
objects or apply load on the printer. Doing so may damage it.
• During replacement, clean the four bobbin holders on the
printer. Burrs generated by friction between the bobbins and
bobbin holders may be adhered to the ink ribbon or
retransfer film, causing printing errors.
to initialize the printer.
B2