Gas Line Connection To Appliance - Valor Legend 936XN Installation And Owner's Manual

10.17 Place a piece of card, thick paper, etc. over the top of
the appliance to protect it. Secure the elbow or
extension at the appliance ducts by drilling and
securing with two #6 tapping screws provided (Lift
the decorative vent collar clear while working). See
figure 17. Make sure that the drill does not
penetrate the inner vent duct.
Fig. 17 Vent duct securing
10.18 Seal the joint between the elbow and the terminal
with the sealing tape supplied (see figure 18).
Fig. 18 Vent joint masking
10.19
Locate the masking collar over the joint so that it
hides the tape. Squeeze the collar as tight as
possible and align the two holes and slots in the
collar. Mark the sealing tape at the position of the
holes (see figure 18).
10.20
Move the masking collar out of the way. Drill for #8
tapping screws at the marked positions. Make sure
that the drill does not penetrate the inner duct.
10.21
Place the masking collar back in position. Squeeze
as tight as possible and fix over the vent joint with
two #8 tapping screws (see figure 18).
10.22
If extensions are installed, seal each extra joint with
tape and cover each joint with a masking collar as
described in sections 10.18 through 10.21. A length
of tape and sealing collar is supplied with each kit.
11. GAS LINE CONNECTION
11.1
Open the control panel door.
11.2
Pull off the two control knobs.
11.3
Detach the control cover panel (see figure 19):-
•
Remove three screws.
•
Lift the panel up
•
Pull the bottom front corner of the panel forward
and out to clear the case and then lift clear.
Fig.19 Control cover panel removal
11.4
Couple the gas inlet pipe to the connector below the
regulator (see figure 20).
13