QUALIFIED
INSTALLER
Level Appliance in Hearth
The backside of each support leg has a leveling bolt. If
necessary, adjust the level of the fi rebox in the hearth.
Leveling
bolt
Front
Re-install Burner Module
Note: If the circulating fan is to be installed it
should be done at this point before installing the
burner module. See instructions packaged with the
fan for details of the fan installation.
Reinstall the burner module using the 4 screws
removed previously.
Re-install Burner
Module (4 screws)
26
Installation
Leveling
bolt
Front View
Fret bracket
Leg
Back
Leveling bolt
Side View
Note: The upper baffl e may be removed to gain more
room for the screwdriver to install the rear screws.
Remove top baffl e
if necessary to gain
space for a screwdriver
(2 screws)
Connect Gas Line and Test Appliance
Connect the gas line to the burner module. Check
for leaks, purge the line, and test-fi re the unit before
installing the window or proceeding with the remainder
of the install—see Connect Gas Supply section.
Re-install Top Baffl e (if removed)
Edge fi ts into cleat at
back of fi rebox
Re-install top baffl e if
removed (2 screws)
Re-install Log Support
Re-install
Log Support
(4 screws)