Table of Contents
Advertisement
18.
FACIA INSTALLATION
18.1
Contemporary front only:
unit with 4 screws (see figure 30).
Fig. 30 Ashlip fixing - contemporary front
18.2
Locate the facia unit to the appliance front - see
figure 31. Locate at the top corners and at the
bottom. We suggest the following order:
1) Angle the top of the facia against the upper part
of the appliance front.
2) Push the facia up between the appliance front
and the appliance top.
3) Push the lower part of the facia against the
appliance front.
4) Lower the facia on to the locations.
.
Fig. 31 Facia location (Left side shown)
Fit the ashlip to the facia
18
19.
19.1
Recheck gas control and thermostat operation.
19.2
Instruct the owner how to operate the appliance.
19.3
Warn that if the ceramic window unit is damaged,
the appliance must be turned off immediately and
not used until the window is replaced.
19.4
Advise that, if necessary, the window may be
removed when the appliance is shut off and cold to
clean the inside or reset the logs if disturbed. Stress
that the window must be replaced securely before
operating the appliance.
19.5
Recommend that the appliance is inspected and, if
necessary, serviced at least once a year.
19.6
Point out the location of the supply shut off valve and
its operation.
19.7
Point out the location of the vent terminal. Advise
that, for safe and efficient operation, no objects
should be placed within 2 feet (60cm) of the vent
terminal.
19.8
Close the control panel door.
FINAL CHECK
Advertisement
Table of Contents
