Base With Legs - Valor Legend 936XN Installation And Owner's Manual

9.2

BASE WITH LEGS

9.2.1 Detach the door retaining bracket (located near the
rear right corner of the appliance main unit) by
removing two screws (see figure 11).
9.2.2.
Swing the bottom of the door forward to release the
bottom pin from the slot in the case and lift the door
clear (see figure 11).
REMOVE BRACKET
SWING DOOR FORWARD
Fig. 11 Door removal
9.2.3
Place the base in position (see figure 12). The rear
of the base may touch the wall but a slight gap is
advisable to stop the stove top from scraping the
wall when placing it on the base.
9.2.4
Mark the floor fixing positions through the holes in
the rear feet.
9.2.5
Remove the base. Drill the floor at the marked
Fig. 12 Leg base positioning
positions and fit plugs if necessary.
9.2.6
Replace the base. Fit woodscrews through the
rear feet and tighten.
9.2.7
Fit the inlet elbow to the supply pipe.
9.2.8
Place the main appliance unit over the base, align
the securing holes (s ee figure 12). Secure with 4
machine screws.
9.2.9 Replace the door as follows:
9.2.9.1
Locate the hinge pin at top of the door into the hole
at the top of the door aperture (see figure 13).
9.2.9.2
Locate the hinge pin at bottom of the door into the
slot in the base. Swing the bottom of the door part
way to the back. A new door retaining bracket is
supplied with the leg and facia kit. Hold this
bracket under the bottom of the base side.
Position it with the two holes at the bottom and
locate the single hole over the bottom door hinge
pin (see figure 13).
9.2.9.3
While keeping the bracket located to the hinge pin,
swing the door and bracket fully backwards. Align
the two holes in the bracket with the two holes in
the base side and fix with the two tapping screws
provided (see figure 13).
LOCATE TOP DOOR HINGE PIN
LOCATE BOTTOM HINGE PIN IN SLOT & SWING DOOR PART
FIT BRACKET TO HINGE PIN & SWING BACK
SECURE BRACKET WITH 2 SCREWS
11
Fig. 13 Door fitting with leg design base
WAY TO BACK