Table of Contents
Advertisement
INSTALLER GUIDE
18.2 To remove the visual baffle.
1. Complete section 19.1
2. Remove the visual baffle, by unscrewing by hand
the two M5 knurled screws in an anti clockwise
direction. Keep these two screws save as they will be
needed later. Carefully slide out the decorative trim and
place carefully to one side.
3. Replace in the reverse order.
18.3 To remove the window door panel.
1. Complete section 19.2
2. Remove the glass door, by unscrewing by hand the
two M5 knurled screws in an anti clockwise direction
located just under the base of the door frame. Keep
these two screws save as they will be needed later.
Carefully pully out at the base then lift up and off the
door and place carefully to one side.
4. Replace in the reverse order.
18.4 To remove the fuel effect and ember wool.
1. Complete sections 19.1 - 19.3
2. Remove the fuel effect in the reverse order to that shown for fitting in the ceramic
guide. The ceramic fuel effect may cause staining / discolouration to decorative
surfaces. It is therefore advisable to protect decorative surfaces.
The ember wool is positioned across the burner carefully lift up all the steel wool and
place carefully to one side. Refer to the installation instructions earlier regarding
placing this ember wool back onto the burner.
3. Replace both in the reverse order.
18.5 To remove the top tray.
1. Complete sections 19.1 - 19.4
2. Lift out the Top tray and carefully place to one side.
There are no screws holding this tray inplace.
3. If glass liners have been fitted only, there will also be
an additional filler top tray to the rear, lift this up also
any place to the side. It is not held inplace by any
screws.
4. Replace in reverse order.
18.6 To remove the base tray.
1.Complete sections 19.1 - 19.5
2. Unscrew the base tray, then remove and place to one
side carefully.
3. Replace in reverse order.
©
Page 39
GDC Group Ltd. NOV 2017
Advertisement
Table of Contents
