Installing the Photoreceptor Drum
These instructions describe the initial installation of the photoreceptor drum.
To install the drum, you will need a drum auxiliary rod (listed on page B–82). Please
read all steps before beginning the installation process.
Installation of the photoreceptor drum should be performed only by an
individual who has received the appropriate training. Do not attempt this
procedure without the drum auxiliary rod, as you may damage the drum.
Exposing the drum to light shortens its life span. Do not expose the drum to
direct sunlight, and install it within five minutes under typical room lighting
conditions. When removing the drum from its packaging, do not touch the
surface of the drum, because fingerprints and scratches can damage the
surface and cause poor print quality.
5–24
CAUTION
Setup