Table of Contents
Advertisement
The customer needs different emulation software
You have replaced the controller board
You have added or replaced the flash memory card
The customer needs to load logos, forms, TIFF files, setup files, and/or font files
to the printer
Emulation software and fonts are supplied on 3.5 inch, double-density diskettes.
Each emulation file is "executable"—you will expand it and copy it into the printer's
flash memory with a single command. The other kinds of files are not executable;
however, before they can be downloaded, you might need to convert them into
downloadable format. You can then copy them to the printer's flash memory as binary
data files, as instructed later in this section.
NOTE: The procedures that follow assume that you have some familiarity with DOS
The lasr2fls Utility Program
The lasr2fls program is a DOS utility that is supplied with the flash software on
diskette. This utility converts logo, form, TIFF, setup, and font files into downloadable
format.
To convert files into downloadable format, do the following:
1. Create a directory on the hard drive and copy the lasr2fls utility to that
directory.
2. Copy all of the files to be converted to the directory where the lasr2fls utility
resides.
3. Change to the drive and directory where the lasr2fls utility resides.
Electrical System and Adjustments
file commands.
3–65
Advertisement
Table of Contents
