Table of Contents
Advertisement
Cable Connections
Power Cord
The procedure to install the power cord is identical for both domestic and
international power cords, using the following power cord part numbers:
P/N 703904–001: for installation in the United States and Canada. The mating
connector for the printer power cord should be a NEMA L6–30P female
connector, rated at 250 VAC and 30 Amps.
P/N 703904–002: for international installation. A European harmonized power
cord must be used instead of the UL/CSA power cord.
The choice of cable plugs is determined by the requirements of the country in which
the printer is installed.
1. Refer to the following figure and remove the screws (2) at the right side of the
lower rear cover.
Setup
Lower rear cover
Figure 5–4
Screws (2)
5–9
Advertisement
Table of Contents
