Setting Operation Options - CYBEX TROTTER Owner's Service Manual

11. Run the treadmill through its full % grade range. Press the Incline
treadmill reaches its highest grade (15%). Next press the Incline
is down to -2% grade. Then press the Incline
0% grade.
12. Press Stop twice to stop the running belt, end the workout review, and return the display
to Dormant Mode.

Setting Operation Options

1. Enter Test Mode by holding down any key while turning on (I) power. The display will read "Elite".
NOTE: After changing any value, you must press Enter to save that value. When you press
enter the display will read "updt" (updated) to confirm your selection.
2. Press the Weight key to set options, change values with L and M keys and press Enter
to save your selection. Each time you press Weight the next set of data is displayed in
the following order:
Unit — Choices are "Eng" or "Euro" measurements. English is the default.
Line: — This is the frequency of the power line that supplies power to your treadmill. The
default setting is 50 Hz for metric consoles and 60 Hz for English consoles. NOTE: If you
have an English console and a 50 Hz power line frequency, then you must change the
default setting from 60 Hz to 50 Hz for the proper elevation frequency.
Scan — This turns on or off the data readout scan (unless a specific data key is pressed
during a workout). Default is on.
Idle (or Workout Review): — This is how long the treadmill retains and displays your
current workout data during a pause in the workout or after a workout. Choices include:
20 seconds; 30 seconds, 40 seconds; 1 minute and 5 minutes; default is 20 seconds.
Setup
&
Assembly
Page 5-12
Cybex TROTTER Elite Treadmill Owner's & Service Manual
key until the
key until the treadmill
key until the treadmill is back to