Cybex TROTTER Elite Treadmill Owner's & Service Manual
• Use a dedicated line when operating the treadmill.
• Connect the treadmill to a properly grounded outlet only.
• DO NOT operate electrically powered treadmills in damp or wet locations.
• Keep the running belt clean and dry at all times.
• Use this treadmill either for consumer or light commercial use only.
• DO NOT leave the treadmill unattended when plugged in and running. NOTE: Before
leaving the treadmill unattended, always wait until the treadmill comes to a complete stop
and is level. Then, turn all controls to the STOP or OFF position and remove the plug from
the outlet. Remove the e-stop key from the treadmill.
• Immobilize the treadmill (when not in use) by removing the e-stop key.
• Inspect the treadmill for worn or loose components before each use. Do not use until worn
or damaged parts are replaced.
• Maintain and replace worn parts regularly. Refer to "Preventive Maintenance" section of
Owner's Manual.
• DO NOT operate the treadmill if: (1) the cord is damaged; (2) the treadmill is not working
properly or (3) if the treadmill has been dropped or damaged. Seek service from a qualified
technician.
• DO NOT place the cord near heated surfaces or sharp edges.
• DO NOT use the treadmill outdoors.
• DO NOT operate the treadmill around or where aerosol (spray) or where oxygen products
are being used.
• Read and understand the Owner's Manual completely before using the treadmill.
• Ensure all users wear proper footwear on or around all Cybex equipment.
• Set up and operate the treadmill on a solid, level surface. Do not operate in recessed areas
or on plush carpet.
• Provide the following clearances: 19.7 inches (0.5 m) at each side, 39 inches (1.0 m) at the
back and enough room for safe access and passage at the front of the treadmill. Be sure
your treadmill is clear of walls, equipment and other hard surfaces.
• DO NOT attempt repairs, electrical or mechanical. Seek qualified repair personnel when
servicing. If you live in the USA, contact Cybex Customer Service at 800-766-3211 (then
press 64). If you live outside the USA, contact Cybex Customer Service at 508-533-4300.
• Use Cybex factory parts when replacing parts on the treadmill.
• DO NOT modify the treadmill in any way.
• DO NOT use attachments unless recommended for the treadmill by Cybex.
Safety
Page 1-3
Need help?
Do you have a question about the TROTTER and is the answer not in the manual?
Questions and answers
what is the max weight that a person can weigh on thr totter 545
The maximum user weight for the CYBEX TROTTER Elite Treadmill is 400 lbs. (181 kg). The document does not mention a CYBEX TROTTER 545 specifically.
This answer is automatically generated
I have a Trotter MG 2100 machine and the seat adjustment pin came out and I can’t get it to engage. This would be the seat where you do the shoulder press and lat pull down exercises. I have taken the back Support seat off so I can see the hydraulic cylinder. I don’t see anything through the slot where the pin would go to have it catch anything. Right now the cylinder just goes up and down, but can only be used in the farthest down position as there is no locking mechanism for the cylinder. Thank you for any help you can provide!