Honeywell Vuquest 3310g User Manual page 99

F8 Example: Send bar code data that starts after a particular
character
Search for the letter "D" in bar codes and send all the data that follows,
including the "D." Using the bar code above:
Command string: F844F10D
F8 is the "Search forward for a character" command
44 is the hex value for "D"
F1 is the "Send all characters" command
0D is the hex value for a CR
The data is output as: DEFGHIJ
Search backward for a character
F9 Search the input message backward for "xx" character from the current
cursor position, leaving the cursor pointing to the "xx" character. Syntax
= F9xx where xx stands for the search character's hex value for its
ASCII code.
Refer to the
page A-4 for decimal, hex and character codes.
Search forward for a string
B0 Search forward for "s" string from the current cursor position, leaving
cursor pointing to "s" string. Syntax = B0nnnnS where nnnn is the string
length (up to 9999), and S consists of the ASCII hex value of each
character in the match string. For example, B0000454657374 will
search forward for the first occurrence of the 4 character string "Test."
Refer to the
page A-4 for decimal, hex and character codes.
B0 Example: Send bar code data that starts after a string of char-
acters
Search for the letters "FGH" in bar codes and send all the data that fol-
lows, including "FGH." Using the bar code above:
Command string: B00003464748F10D
B0 is the "Search forward for a string" command
0003 is the string length (3 characters)
46 is the hex value for "F"
47 is the hex value for "G"
<CR>
ASCII Conversion Chart (Code Page 1252),
ASCII Conversion Chart (Code Page 1252),
beginning on
beginning on
5 - 11