Note: If you are having unexpected results with this programming code,
scan the Activate Defaults bar code on
programming code above.
Wincor Nixdorf Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Wincor
Nixdorf terminal. This bar code sets the baud rate to 9600 bps and the
data format to 8 data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code,
scan the Activate Defaults bar code on
programming code above.
NCR Bioptic Settings
Wincor Nixdorf Terminal Settings
page 1-5
first, then scan the
page 1-5
first, then scan the
2 - 7