End Character Activation After Good Read; Character Activation Laser Timeout - Honeywell VOYAGER 1200G User Manual

Single-line laser scanner
Hide thumbs Also See for VOYAGER 1200G:
Table of Contents

Advertisement

ger scanning. Scan the bar code below, then use the
Programming Chart
to read the alphanumeric combination that represents that ASCII character.
Scan
Save
to finish.
Activation Character

End Character Activation After Good Read

After a bar code is successfully detected and read from the scanner, the
laser can be programmed either to remain on and scanning, or to turn off.
When End Character Activation After Good Read is enabled, the laser
turns off and stops scanning after a good read. If you scan Do Not End
Character Activation After Good Read, the laser remains on after a good
read. Default = End Character Activation After Good Read.
Do Not End Character Activation
After Good Read
* End Character Activation After
Good Read

Character Activation Laser Timeout

You can set a timeout for the length of time the laser remains on and
attempting to decode bar codes when using Character Activation Mode.
Set the length (in milliseconds) for a timeout by scanning the bar code
below, then setting the timeout (from 1-65535 milliseconds) by scanning
digits from the
Programming
Chart, then scanning Save. Default = 5000
ms.
Character Activation Laser
Timeout
3 - 14

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents