5.7 Aggregator Information; 5.8 State Activity - Waters Network Systems PSX1008-GTX Operating Manual

standby and able to aggregate if a work port fails. If it set to local static trunking
group, the number must be the same as group ports.
5. Select the ports to join the trunking group
6. If LACP enabled, you can configure LACP to either Active/Passive status in
each ports.
7. Select Apply to apply the settings.

5.7 Aggregator Information

The Aggregator Information screen displays the LACP information.

5.8 State Activity

The State Activity screen provides the following information:
Active (select) - The port automatically sends LACP protocol packets.
Passive (no select) - The port does not automatically send the LACP protocol
packets, and responds only if it receives LACP protocol packets from the opposite
device.
A link with either two active LACP ports or one active port can perform dynamic LACP
trunking. A link with two passive LACP ports will not perform dynamic LACP trunking
because both ports are waiting for the LACP protocol packet from the opposite device.
When you select a trunking port, active status will be created automatically for an active
LACP.
Waters Network Systems User's Manual
PSX/MS1008 Models with Gigabit Uplink
Page 39