Table of Contents
Advertisement
responds only when it receives LACP protocol packets from the opposite device.
4.46.3
LACP Status
This screen provides the status of the LACP configuration.
4.5
Reboot Switch
Rebooting the switch provides two choices.
Default: Reset switch to recover default configuration.
Restart: Reboot the switch with new configuration settings.
4.6
Xmodem Upgrade
To perform the Xmodem upgrade, press the X key to start upgrading for Xmodem.
Disconnect the terminal and modify baud rate to 57600bps. Then, reconnect. Once
attached, follow these instructions:
1.
Select send file under the transfer menu on the menu bar.
2.
Select the browse button to select the path.
3.
Select 1K Xmodem from protocol.
4.
Select Send.
5.
After successfully upgrading the new firmware, please modify baud rate to
9600bps.
5.0
Web-Based Management
This section introduces the configuration and functions of the Web-based management
of 1008 switch. The 1008 switch provides an embedded HTML website residing in flash
memory. Management functions can be performed from anywhere on the network
through a standard Web Browser.
NOTE: If you are using Win2000 with the Service Pack 2 function, the web
management function will be not be displayed correctly if the IE is below Version 5.5.
5.1
Accessing Management Functions through the Web
In order to use the management functions via your Web Browser, the following defaults
must be set. Use the Console connection to modify the IP for use with your web
browser.
Waters Network Systems
User's Manual
PSX/MS1008 Models with Gigabit Uplink
Page 33
Advertisement
Table of Contents
