Waters Network Systems PSX1008-GTX Operating Manual page 37

Console port information – The console connection is a standard interface used to
communicate with the switch via the serial port on the workstation. Section 4.1
describes the console connection.
Port controls - The following settings can be changed:
o State - You can disable or enable this port control.
o Auto Negotiation - Auto negotiation can be enabled or disabled per port
o Speed Setting - You can set 100Mbps or 10Mbps speed (Port 1 ~ Port 8).
o Duplex setting - Set full-duplex or half-duplex mode.
o Flow control setting – Flow control function is set to enable or disable.
Link aggregation – Trunking provides a standardized means for exchanging
information between partner systems on a link. This allows their Link Aggregation
Control instances to reach agreement on the identity of the Link Aggregation Group
to which the link belongs, move the link to that Link Aggregation Group, and ensure
that its transmission and reception functions in an orderly manner. Link aggregation
allows you to group up to eight consecutive ports into a single dedicated connection.
This feature can expand bandwidth to a device on the network. LACP operation
requires full-duplex mode.
Waters Network Systems
recommendation is to enable STP.
Enable Internet Group Multicast Protocol – This option allows
you to enable IGMP protocol
VLAN Operation Mode – You can make the selection between
802.1Q (Port Based) without GVRP VLAN mode, 802.1Q (Port
Based) with GVRP VLAN mode or Port Based.
IGMP Query Mode - Recognize different Query from client or server
to decide which Queryer will be the first priority. There are three
modes to choose from:
Auto Mode: Choose the indicated Switch, which has the
smallest IP address to be the Queryer.
Enable Mode: Enable one of Switches to be the Queryer.
Disable Mode: Disable the other Switches from being the
Queryer.
For detailed information, refer to the IEEE 802.3ad
User's Manual
PSX/MS1008 Models with Gigabit Uplink
Page 37