Desktop Installation; Attaching Rubber Feet; Power On - Waters Network Systems PSX1008-GTX Operating Manual

3.6

Desktop Installation

Choose a surface for your switch that is clean, smooth, level, sturdy and with a power
outlet nearby. Make sure there is enough clearance around the switch to allow
attachment of cables, power cord and air circulation.
3.61

Attaching Rubber Feet

1. Make sure mounting surface on the bottom of the switch is free of grease and dust.
2. Remove adhesive backing from the rubber feet.
3. Apply the rubber feet to each corner on the bottom of the switch.
Figure 3-8. Attaching Rubber Feet to each corner on the bottom of the switch
3.62

Power On

Connect the power cord to the AC power socket on the rear panel of the switch. Check
the power indicator on the front panel to see if power is properly supplied.
Waters Network Systems User's Manual
PSX/MS1008 Models with Gigabit Uplink
Page 14