Operation Of Your Neo - Rinnai Neo Operation Manual

Operation of your Neo

Your controller has a built-in child lock function that requires pressing two buttons
simultaneously. This function cannot be overridden. To turn the controller on, press PWR
and OK at the same time. Pressing PWR will switch the controller off.
Fan
On start-up, the fan will start
approximately four minutes after
the heater is switched on. This
delay is to reduce the amount of
cold air being pushed out into the
room.
On shut-down, the fan will stop
approximately eight minutes after
the heater is switched off. This is to
cool the appliance down.
Modes of operation
Your Neo has three modes of
operation:
- Manual (set temperature)
mode
- Automatic (programmed timer
and temperature) mode
- Flame control mode
IMPORTANT
The Neo is designed to run as
efficiently as possible.
When in manual or automatic
modes, the heater will switch itself
off if the room reaches the set
temperature, i.e. in smaller rooms
that heat up quickly. When this
occurs, the flame indicator on your
controller will rise and fall every
few seconds to indicate the heater
is still operational. The heater
will restart again once the room
temperature falls below the set
temperature.
ALWAYS check your wireless
controller before going to bed or
leaving the building to ensure the
heater has been switched off.
If you want the Neo to operate
regardless of room temperature,
12 | Neo operation guide: 11907-E 05-14
you can adjust the controller to
flame control mode only.
Start-up
When turning the Neo on, the
heater will automatically go to the
highest setting for approximately
45 seconds—this is to establish the
flame pattern. You can adjust the
heater during this period, but there
will be a 45 second delay.
Over temperature automatic
shut off
The controller when operating
in any of the three modes will
automatically shut down and
switch the heater off if the room
temperature exceeds 40 °C for
more than three minutes—this is a
safety feature.