Table of Contents
Advertisement
If the fresh water system was not installed, you may elect to use this switch as an accessory switch.
Please check the amp rating of any new component and/or additional accessory before installation.
5
Baitwell Pump - The baitwell pump is located in the bilge area and is plumbed to a seacock (ball
valve). This pump is also used for the raw water washdown. See the Sea Water section of this
manual for instructions on using the raw water washdown fitting.
For the pump to operate properly you need to make sure the seacock is in the open position. The
seacock is wide open when the yellow seacock lever is vertical. When the yellow seacock lever is
horizontal, the seacock is closed.
The underside of the seacock thru-hull is equipped with a scoop to allow the water to be picked up
even when the boat is on plane. When the boat is not in the water or the baitwell pump is not going
to be used for an extended period of time, the seacock valve should be in the closed position. To
activate the pump, depress the switch to the up or forward position. To turn the pump off after the
baitwell tub is full, depress switch to the down or aft position.
6
Cockpit Lights (Optional) – Your vessel may be equipped with cockpit/courtesy lights. The lights
have LED (light emitting diode) bulbs with a lifespan of approximately 10,000 hours. To activate the
lights, depress the switch to the up or forward position. The lights give off a soft warm light which
should not affect your night vision, but will still provide you with enough light to safely move around
your cockpit in low visibility conditions.
7
Baitwell Light - To activate the baitwell light, depress the switch to the up or forward position. This
will activate the LED (light emitting diode) light inside your baitwell tub. It is a soft white light that will
keep your bait moving and lively. It will also help you locate your bait on those early morning or late
night fishing trips. To turn the light off, simply depress the switch to the down or aft position.
8
Fish Box Pump - This switch directs power to the fish box macerator pump, which allows you to
drain the water and debris from the aft fish boxes. The macerator pump allows you to pump all the
water, ice and scales out of the aft fish boxes by grinding up the debris and discharging it overboard.
To access the backside of the console and/or switch and breaker panel, release the two clasps on the
forward side of the console (just aft of the windshield) and pull the top of the console toward the transom.
Lighting Systems
Cockpit Lights (Optional)
The cockpit lights are small circular lights located around the cockpit area
near the helm seat. Locate the 2-way cockpit light switch on the switch panel
and press the switch in the forward position to turn on the cockpit lights. Press
the cockpit light switch in the down or aft position to turn the lights off.
Cabin Lights
The dealer-installed battery provides power to the two cabin lights. Each light can be adjusted to direct
the light to most areas in the cabin. Turn the base of the light to the left to turn the light on and to the right
to turn the light off.
Navigation and Anchor Lights
The navigation and anchor lights are required to be used for operation at night or under low visibility
conditions to indicate your position to other boaters. Visually verify the operation of your navigation and
anchor lights and make sure that the lights are free from obstructions. You should check your navigation
lights monthly during optimum visibility conditions.
17
Hide quick links:
Advertisement
Table of Contents
