Remote Spot Light (Optional); Spreader Lights And Courtesy Light (Optional) - Pro-Line Boats 23 express Owner's Manual

•
When you are underway in low visibility conditions, you should have the Nav/Anc switch
in the up or forward position. This will activate the navigation lights, as well as your
anchor light.
•
When you are anchored or in low visibility conditions, you should turn on the anchor light.
Press the Nav/Anc switch to the down or aft position to turn on the anchor light.
The navigation lights consist of a pair of lights that are mounted at the bow of
the boat. The red light is installed on the port side and the green light is
installed on the starboard side.
The U.S. Coast Guard requires that the anchor light be installed at the highest
point on the boat and must be secured in the up position when you are
underway. Therefore, this light will be installed as follows based upon the
optional top that you may have selected:
•
Hard Top – Light will be mounted on the center of the top
•
Bimini top or no top – Light will be installed on top of the
windshield frame.

Remote Spot Light (Optional)

The installation of the remote spot light requires the optional hard top. The remote spot light is mounted
to the forward area of the top. To operate the remote spot light, locate the remote spot light panel that is
installed on the console.
The switch on the right side of the panel allows you to turn the light on and off. The red LED light located
in the center of the panel will be lit when the spot light is turned on. Once the spot light is turned on, the
all around toggle lever (on the left side of the panel) can be moved in an up, down, left or right position to
rotate the light assembly in the desired direction.
Remote Spot Light

Spreader Lights and Courtesy Light (Optional)

The installation of the spreader lights and courtesy light requires the optional hard top. The spreader
lights are mounted to the aft edge of the hard top frame. The dome shaped courtesy light is mounted to
the bottom of the hard top storage box. Two push in switches for the spreader lights and courtesy light
are located on the base of the courtesy light.
•
To operate the dome shaped courtesy light - Press the switch labeled courtesy once to
turn on the white courtesy light. When you press the same switch a 2
courtesy light will be turned off and the red courtesy light (for night vision) will turn on.
Press the same switch a 3
•
To operate the spreader lights - The spreader light switch operates in the same manor as
the courtesy light but only needs to be pressed in once to be turned on and once again to
be turned off.
rd
time to turn off the red courtesy light.
Remote Spot Light Control Panel
nd
time, the white
18