Table of Contents
Advertisement
Porta-Potti with Filler Board
The porta-potti includes a 2.8-gallon holding tank. To operate the porta-potti system:
•
Set the portable toilet on its front side so the cap on the holding tank is in a vertical
position. Remove the cap and add SeaLand brand holding tank deodorant following the
instructions on the deodorant container. Replace the cap firmly.
•
Before using: Set the portable toilet in the upright position and remove the cap located
on the right, rear side of the fresh water tank. Fill with fresh water just below the neck of
the fresh water inlet. Depress the bellows pump to add water to the bowl.
•
After using: To flush, open the slide valve by pulling out the handle and press the
bellows pump one or more times. After flushing, close the slide valve by pushing the
handle.
Before operating the porta-potti head system, refer to the manual in your owner's packet supplied by the
porta-potti manufacturer for specific operating instructions.
Fresh Water System (Optional)
The freshwater system includes a cabin sink, cockpit shower, and a 10-gallon freshwater tank.
Note: There must be fresh water in the fresh water tank in order for the fresh water pump
to operate. Operating the pump with an empty tank could cause serious damage to the
pump.
Fresh Water Tank and Fill (Optional)
The 10-gallon capacity fresh water tank can be filled
via the stainless steel fresh water tank fill (labeled
water) located on the starboard aft corner of the
transom.
The stainless steel vent is located just
forward of the transom door. The water tank, which
is installed on a shelf in the bilge area, can be
accessed via the bilge hatch in the floor of the aft
cockpit.
To fill the tank, twist the cap on the stainless steel
fitting. The cap is connected to the fitting by a chain
or cable so that it will not fall into the water and/or
get lost. Use a garden hose to fill the fresh water
tank through this fitting.
Important: Fill the tank with potable water only. Refilling the tank often will help to keep it
a source of clean fresh drinking water. Never fill the fresh water tank with anything other
than fresh water.
Fresh Water Pump (Optional)
The fresh water pump is installed in a cut out area on top of the
starboard stringer and is accessible via the bilge hatch. Locate
the fresh water pump switch (labeled fresh water) on the switch
panel and move the switch to the on position. Next go to the
transom and turn on the faucet/nozzle to verify that water is
coming out of the faucet/nozzle.
If the fresh water system is not in going to be in use, return to
the switch panel and turn the fresh water switch to the off
position.
Fill & Vent
Hose to the
Fresh Water
Fresh Water
Pump & Filter
Hoses
Pump
21
Hide quick links:
Advertisement
Table of Contents
