Using The Menus; Selecting The Interface Language; About Memory Channels - Kemppi FastMig X 450 Operating Manual

4. Adjustment knob
Turn the knob to change the value of the selected parameter
5. Menu browsing buttons
Use up and down arrows to move the selection up and down in the menu structure.
6. Menu shortcut buttons
• F1 displays the channel information
• F2 selects the user
• F3 selects another wire feeder sub system as a setup target
7. LCD menu display
8. Soft key buttons for menu selection
Use these buttons to select menu items. Their functions depend on selected menu items.
4.2

Using the menus

4.2.1 Selecting the interface language

The default menu language is English. If you want to select another menu language, do the
EN
following:
1. Connect the mains power and switch on the power source at the main switch.
• If this is the initial system activation, you may need to press and hold the POWER
ON button in the to left corner of the X 37 control panel. Hold the button down for 5
seconds.
Press the MENU button to display the main menu, which includes 7 menu items.
2.
• You can move around in the menu list by pressing the up and down arrow buttons.
• As you browse the menu item list, the currently selected item is shown at the bottom
of the display, marked as 1/7, 2/7, 3/7 etc.
• The selected menu item is marked with a black arrow-shaped cursor.
3. Browse to the menu item LANGUAGE (5/7) and press the SELECT soft key button.
Browse to your language and press the SELECT/SAVE soft key button. Your language choice is
4.
now confirmed and will remain selected unless you change it later.

4.2.2 About memory channels

You can have several setups of welding parameter values for use in various welding
applications. These setups (or welding jobs) are stored as memory channels in X 37 control
panel.
Up to 10 user profiles can be defined in one FastMig X 450 unit, and each of them are assigned
up to 10 memory channels. So, you have maximum of 100 memory channels to store your
frequently used welding jobs. In addition to them, there are 10 memory channels available for
MMA/CC/CV use.
To define a new welding job, you need to make the necessary welding parameter selections
and then save them to a memory channel of your choice.
When you want to use these settings, you simply select the corresponding memory channel
number on the power source or wire feeder control panel and start welding. Only the most
often used controls are available in the wire feeder control panel, making welding easy and
convenient.
You can use and update any memory channel, unless it is locked via the four-digit
administrator pin code lock.
12
FastMig X 450