Welding Software Delivery Profile - Kemppi FastMig X 450 Operating Manual

ADMINISTRATOR MENU
Change PIN Code
Ask PIN
EN
BUTTON FUNCTIONS
ON / OFF button
F1 button
F2 button
F3 button (WF#)
Channel +/-
Up/down arrow
Right and left soft
key buttons
4.5

Welding software delivery profile

Connected to Kemppi's MXF or MXP wire feed units, FastMig X 450 power source makes a very
efficient, multi-process welding system.
After delivery and installation, your system will include welding software specified at the point
of order.
If your welding needs change and you wish to update your FastMig X 450 system in the future,
you can order additional welding programs or Wise™ and Match™ welding software and load
them to your system with Kemppi DataGun field programming device.
See further information about the available welding programs, modified processes, Match™
functions and special enhanced arc performance solutions in the wire feeder's operating
manual or on Kemppi's web site at www.kemppi.com.
More welding programs are available by purchasing MatchCurve and MatchCustom products.
20
FastMig X 450
Factory PIN code is 0000
OFF, StartUp, Menu Factory setting is OFF
• Short press returns the panel to default initial view (channel information).
• Long press (>5 sec) turns X 37 panel and wire feeder panel XF 37 ON or OFF.
• Keeping this button pressed while turning the machine ON restores to factory settings. The
panel asks for a confirmation before restoring to defaults.
• If X 37 panel is OFF and a wire feeder panel XF 37 is turned ON, the X 37 panel will also be turned
ON and linked automatically to this wire feeder panel.
• Gives further information of selected memory channel.
• Keeping F1 pressed while turning the machine ON restores the menu language to English.
• Browses and selects users: 1...10, Administrator.
• When MMA/CC/CV is selected, only Administrator is allowed.
• Selects another wire feeder as a setup target. Panel allows selecting only those WF numbers that
are found connected on the system.
• When MMA/CC/CV is selected, the display shows text "MMA/CC/CV Mode".
Browses and selects memory channels.
Moves the selection up and down in the menu.
Function depends on which menu command is active. The function is shown on the display.
Administrator pin code change.
PIN code inquiry selection
OFF: No PIN code inquiry.
StartUp: Control panel X 37 always asks
for the PIN code when the machine is
turned on. Wire feeder panel XF 37 is
not affected and always works without
PIN.
Menu: Control panel X 37 asks for
the PIN code every time when MENU
button is pressed and when the display
is in channel info mode (in start-up
view). PIN code inquiry is made only
once when entering the menu. After
that the menu button can be pressed
any time without PIN inquiry.