1.6 Camera Installation
Please follow the instructions mentioned below to set up your IP camera.
Unpack the product package and check if anything's missing.
1.
Connect the Ethernet cable to your local area network, and connect the
2.
other end to the LAN jack of this IP camera.
NOTE: You can skip this step if you plan to use wireless LAN only.
Plug the power adapter to the wall socket, and connect the power
3.
connector to the power jack located at the bottom of the IP camera.
4. For the wireless version, connect the antenna to the antenna bases, which
is located at the top of this IP camera.
5. Place the camera at a secure place, and point the camera to the place you
wish to monitor. If you wish to hang the camera on the ceiling or wall,
please use the tripod connector.
6. Launch Internet Explorer on your computer, and follow the instructions
given in the next section to set the IP camera.
DG-SC2600/DG-SC2600W User Manual
13