Digisol DG-SC2600 User Manual page 39

Available
Networks
SSID
DG-SC2600/DG-SC2600W User Manual
point).
You can set to 'Adhoc' when you don't have any wireless
access point, but your computer has wireless network
card. Set to 'Infrastructure' when you have wireless
access point, and
wired/wireless network connection.
Here shows all wireless access points found by this IP
camera. Please note not all access points will be
displayed at the same time, if the access point you
expected to connect does not appear, you may have to
click 'Refresh' button for several times until it appears.
The descriptions of all fields is listed below:
Connect: You can select the wireless access point you
wish to connect here.
SSID: the SSID of all found wireless access points will
be shown here. Some wireless access points may hide
their SSID; in this case, you have to identify them by
their MAC address.
MAC Address: If there are many wireless access points
in proximity or if some wireless access point hides its
SSID, you can use MAC address to distinguish them.
Signal: Shows the radio signal strength in percent.
Channel: Shows the radio channel of this wireless
access point.
Encryption: Shows the encryption type used by this
wireless access point. You must use the same
encryption type if you wish to connect to a certain
wireless access point. If the wireless access point does
not use encryption, 'Disabled' will be displayed here.
Network Type: Shows the network type of a certain
wireless access point (Infrastructure or Adhoc).
Input the SSID of the wireless access point you wish to
connect. It should be less than 32 alphanumerical
characters.
39
you have computers with