Digisol DG-SC2600 User Manual page 82

Sender E-Mail
Address
SMTP Server
SMTP port
SMTP Auth
SMTP Account
SMTP Password
OK
Cancel
DG-SC2600/DG-SC2600W User Manual
Specify the email address of email sender.
Specify the IP address or host name of the SMTP server
you wish to use. For most of ISPs they will only allow its
subscriber to use their SMTP server, if you don't know
which SMTP server you should use, please refer to the
setting of your email software or ask your ISP / network
administrator.
Specify the port number of the SMTP server you wish to
use here. By default (and the setting of most of SMTP
servers) it is '25'.
Select 'Enable'
authentication, select 'Disable' if it's not required. If you
don't know if your SMTP server requires authentication,
please refer to the setting of your email software or ask
your ISP / network administrator.
Input the SMTP account (username) of your SMTP
server here. In most cases, it's the same as your POP3
username (the one you use to receive email). Please
refer to the setting of your email software or ask your ISP
/ network administrator if you're not sure about this.
Input the SMTP password of your SMTP server here. In
most cases, it's the same with your POP3 password (the
one you used to receive email). Please refer to the
setting of your email software or ask your ISP / network
administrator if you're not sure about this.
Save settings in this tab.
Discard all changes done in this tab.
82
if your SMTP server requires