2.5.3 Utilities
This menu allows you to upgrade firmware, clear all settings, reboot the IP
camera, and switch LED lights on/off.
The description of every setting in this menu will be given below
Item
Upgrade
Firmware
Reset to Factory
Defaults
DG-SC2600/DG-SC2600W User Manual
If you downloaded latest firmware file from our website,
you can click 'Browse' button to pick the firmware file
located on your computer's hard drive and you can
upload the firmware file to the IP camera.
After you selected a proper firmware file from your
computer, click 'Upgrade Firmware' button to start
upgrade. DO NOT DISCONNECT NOW.
If the firmware file you provided is invalid or you didn't
provide the firmware file, you'll be prompted to select
another valid firmware file again.
The IP camera will reboot after the upgrade procedure is
done.
Clear all settings in the camera. Please think again
before you do this, and then click this button to reset all
settings.
NOTE: IP address will be reset to default value
'192.168.2.3' also. You'll need to change the IP address
setting of your computer if the IP address of your
computer does not begin with '192.168.2', and subnet
mask is not '255.255.255.0', or you'll not be able to
connect to this IP camera again.
58
Description
: