Setting The Exposure Mode - Dalsa P-2 Series User Manual

28
2.

Setting the Exposure Mode

To select an exposure mode, use the command:
Syntax:
Syntax Elements:
Notes:
Related Commands:
Example:
Setting Line Rate
Camera must be operating in exposure mode 2.
To set the line rate, use the command:
Syntax:
Syntax Elements:
Notes:
Related Commands:
Example:
03-32-00493-11
Then, when applicable, use the commands
and/or (mode 2 or 6), to set the exposure time. Refer to Setting Line Rate and
set
Setting Exposure Time below for details.
sem i
i
To obtain the current value of the exposure mode, use the
command gcp.
ssf, set
sem 3
ssf i
i
•
To read the current line rate frequency, use the command
gcp.
•
If you enter an invalid line rate frequency, the valid range of
values will be displayed.
sem, set
ssf 3000
(mode 2 only) to set the line rate
ssf
Exposure mode to use. Factory setting is 1. Refer to
Table 9 on page 27 for a list of available modes.
Desired line rate in Hz. Allowable range is 1000Hz to the
camera's maximum line rate. See Table 1. Piranha2
Operating Requirements and Ranges for maximum line
rates.
Piranha2 User's Manual
DALSA