Setting Baud Rate; Setting The Data Mode - Dalsa P-2 Series User Manual

26

3.6 Setting Baud Rate

To set the speed of the camera serial communication port, use the command:
Syntax:
Syntax Elements:
Notes:
Example:

3.7 Setting the Data Mode

To select the camera output mode, use the command:
Syntax:
Syntax Elements:
Notes:
Example:
In the table below, ports A-F refer to ports in the Camera Link specification.
Table 8: Mode Selection Values
Mode
0
1
2
3
To obtain the current data mode, use the command
03-32-00493-11
sbr i
i
Baud rate. Available baud rates are: 9600 (Default), 19200, 57600,
and 115200.
•
Power-on rate is always 9600 baud.
•
The rc (reset camera) command will not reset the camera to the
power-on baud rate.
sbr 57600
sdm i
i
See Table 8: Mode Selection Values below for allowable parameter
values.
To obtain the current data mode, use the command gcp.
sdm 0
Description
8-bit, using A/B/C/D ports for single processor configuration
10-bit, using A/B/C and D/E/F for single processor configuration
8-bit using ports A/B and D/E for dual processor configuration
10-bit, using A/B/C and D/E/F for dual processor configuration
.
gcp
Piranha2 User's Manual
DALSA