Setting And Reading Prnu Coefficients; Generating Test Patterns - Dalsa P-2 Series User Manual

39
To read the FPN coefficient, use the command:
Syntax:
Syntax Elements:
Example:

3.16 Setting and Reading PRNU Coefficients

You can set or read an individual pixel's PRNU coefficient.
To set the PRNU coefficient, use the command:
Syntax:
Syntax Elements:
Example:
To read the PRNU coefficient, use the command:
Syntax:
Syntax Elements:
Example:

3.17 Generating Test Patterns

The camera can generate a test pattern to aid in system debugging. Use the command
svm 2
at 0 again. Use the test pattern to verify the proper timing and connections between the
camera and the frame grabber.
End-of-line Sequence
To further aid debugging, the camera can generate an end-of-line sequence. The end-of-
line-sequence outputs "aa", "55", "aa", "line counter", "line average", "pixels above
threshold", "pixels below threshold", "derivative line sum". To activate the end-of-line
sequence, use the command
command
03-32-00493-11
gfc i
i
The pixel number to read.
gfc 10
spc i i
i
The pixel number from 1 to the pixel count.
i
Coefficient value in a range from 0 to 511 where:
PixelPRNU
spc 10 50
gpc i
i
The pixel number to read.
gpc 10
to activate the test pattern. The test pattern is a ramp from 0 to 255DN, then starts
els 1
.
els 0
= +
i
1
512
. To disable the end-of-line sequence, use the
Piranha2 User's Manual
DALSA