Auxiliary Harness (H2), 6-Pin Connector - Python 513 Installation Manual

➤ Auxiliary harness (H2), 6-pin connector

H2/1
LIGHT BLUE
This wire produces a (-) 200mA output for progressive locks in which the driver
door unlocks first and the remaining locks unlock with a second press of the
unlock button.
H2/2 WHITE/BLACK
This wire provides 200 mA programmable output whenever the transmitter
button(s) controlling AUX 3 is pressed. This output can be programmed to pro-
vide the following types of outputs
• Validity: Output that sends a signal as long as the transmission is re-
ceived.
• Latched: Output that sends a signal when the AUX channel button is
pressed and continues until the same button is pressed.
• Latched, reset with ignition: Similar to the latched output, this type of output
turns On the first time the AUX channel button is pressed, and turns Off the
next time the same button is pressed. This type of output additionally stops
and resets whenever the ignition is turned On and then Off.
• 30 seconds (60, 90) timed: The output sends a continuous signal for 30
seconds.
Note: Bitwriter® programs from 1 to 90 seconds.
© 2009 Directed Electronics. All rights reserved.
(-) 200mA 2nd UNLOCK OUTPUT
(-) 200mA PROGRAMMABLE AUX 3 OUTPUT
Warning! Never use this wire to drive anything
but a relay or a low-current input, supplied out-
put is only 200mA. Connecting directly to a
solenoid, motor, or other high-current device
will cause the module to fail.
21