Table of Contents
Advertisement
Model 750
Owner's Guide
This device complies with part 15 of FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including inter-
ference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
device.
Advertisement
Table of Contents
Related Manuals for Python 750
Summary of Contents for Python 750
- Page 1 Model 750 Owner’s Guide This device complies with part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including inter- ference that may cause undesired operation.
-
Page 2: Table Of Contents
Table of Contents System Maintenance ..........2 Your Warranty . -
Page 3: Your Warranty
What is included The control module A pair of two-button transmitters A Stinger ® DoubleGuard ® dual-output shock sensor The Revenger ® Soft Chirp ® six-tone programmable siren The red Status LED indicator light A push-button Valet ® switch Your warranty card FailSafe ®... -
Page 4: Transmitter Channels
Transmitter Channels Button I Button II Button III Channel I The arm/disarm and panic functions, are usually controlled by Button I. Channel II The Silent Mode ™ /trunk release function, is usually controlled by Button II. Silent Mode ™ and Remote Valet ®... -
Page 5: Using Your System
Using Your System Arming You can turn on, or arm, the system by pressing button I of your transmitter for one second. When the system arms, you will hear a short siren sound, or chirp, and see the parking lights flash once. If the vehicle’s power door locks are controlled by the system, the doors will lock. -
Page 6: Arming While Driving
to disarm the system with your transmitter if you inadvertently open the door while the system is armed, while still providing instant response (even if the door is immediately closed). • Turning on the ignition key will trip the same two-stage response as opening a door. -
Page 7: Disarming Without A Transmitter
to check the vehicle visually. The trigger will stop, but the vehicle will remain protected. To disarm with the transmitter during a trigger, press Button I on your transmitter. The siren will stop sounding. Next press Button I once more and the system will chirp four or five times (reporting the trigger) and disarm. -
Page 8: Valet ® Mode
Valet ® Mode You can prevent your system from automatically arming and triggering by using Valet ® Mode. This is very useful when washing the vehicle or having it serviced. In Valet ® Mode, the system will not arm, even with the transmitter, but all convenience functions (door locks, trunk release, etc.) will work normally. - Page 9 trigger the system while it is being bypassed, the 60-minute bypass period will start over. This ensures that a sensor that continuously triggers will remain bypassed. Doors are covered by NPC ™ differently: If the alarm is triggered by an open door for three full cycles (one and one half minutes), the doors will be by- passed until the trigger ceases.
-
Page 10: Diagnostics
Diagnostics The microprocessor at the heart of your system is constantly monitoring all of the switches and sensors connected to it. It detects any faulty switches and sensors and prevents them from disabling the entire system. The micro- processor will also record and report any triggers that occurred during your absence. -
Page 11: Table Of Zones
Table of Zones The zone number is the number of LED flashes used by the system to iden- tify that input. The standard input assignments are listed below, along with spaces to write in any optional sensors or switches you have had installed. Zone (Number of LED Flashes) Description... -
Page 12: Code Hopping Explained
Code Hopping ™ Explained The receiver and transmitters each use a mathematical formula called an algorithm to change their code each time the transmitter is used. This tech- nology has been developed to increase the security of the unit. The control unit knows what the next codes should be. - Page 13 NOTE: If the door is open when the ignition is turned on, the doors will not lock. • Panic mode enabled/disabled with the ignition on. (Some states have laws against siren capability in a moving vehicle). • Automatic Engine Disable (AED) on or off. The purpose of the feature is to pro- tect the vehicle from being stolen at all times, regardless of whether or not the alarm is armed.
-
Page 14: Vehicle Recovery System (Vrs )
Vehicle Recovery System (VRS ® The optional Vehicle Recovery System feature is designed to ensure that any unauthorized user of your vehicle (even if using your keys and remote con- trol) will not be able to permanently separate you from your vehicle. The VRS feature cannot prevent a carjacking attempt, however, it does ®... -
Page 15: Arming The Vrs
Arming the VRS ® To arm the VRS ® , push the button once. This can be done before driving or while driving the vehicle. Once the system is armed, it will go into its triggered sequence (see below) if any door is opened and closed. If you are forced from the vehicle the system will trigger as the door will be opened and closed as you leave the vehicle. -
Page 16: Disarming The Vrs
From this point on, when the ignition key is turned off, the VRS ® will immediately turn on the FailSafe ® starter kill. This will pre- vent the vehicle from being restarted, thus immobilizing it at that spot. Three minutes after the constant siren output begins, the flashing parking lights and the siren will stop. -
Page 17: Glossary Of Terms
Glossary of Terms Control Unit The “brain” of your system. Usually hidden underneath the dash area of the vehicle. It houses the microprocessor which monitors your vehi- cle and controls all of the alarm's functions. FailSafe ® Starter Kill An automatic switch controlled by the security system which prevents the vehicle’s starter from cranking whenever the system is armed. -
Page 18: Security & Convenience Expansions
Security & Convenience Expansions Here we have listed only some of the many expansion options available. Please consult your dealer for a complete explanation of all the options avail- able to you. Field Disturbance Sensor: An invisible dome of coverage is established by the 508T “radar”... -
Page 19: Quick Reference Card (Removable)
QUICK REFERENCE OPERATING CARD: Arming You can turn on, or arm, the system by pressing Button I of your transmitter for one second. When the system arms, you will hear a short chirp, and see the parking lights flash once. Arming While Driving Press Button I on your transmitter while the vehicle is running. - Page 20 Card Reference System ® The company behind DEI is Directed Electronics, Inc. ® Since its inception, the company known as Directed Electronics, Inc. (DEI ) has had one purpose - to bring the proven advantages of micro- ® processor and I.C. technology to the automotive industry. As a recipient of numerous patents, DEI ®...