Python 513 Installation Manual page 28

H3/2 VIOLET/WHITE
This input provides information to the unit about the engine's revolutions per
minute (RPMs). In vehicles with conventional coils this wire can be connected
to the negative side of the coil - or to the non-common wire at the fuel injector.
Once connected, you must teach the system the tach signal. (See
section of this guide.)
H3/3 BROWN
This wire MUST be connected to the vehicle's brake light wire. This is the wire
that shows (+) 12V when the brake pedal is depressed. The remote start will be
disabled or shut down any time the brake pedal is depressed.
H3/4 GRAY
This wire MUST be connected to a hoodpin switch. This input will disable or shut
down the remote start when the hood is opened. It will also trigger the security
system if the hood is opened while the system is armed and report Zone 6.
H3/5 BLUE/WHITE
This wire supplies a 200mA output as soon as the module begins the remote
start process. The Blue/White wire can also be used to activate the defogger
trigger (latched/pulsed), 10-seconds after the remote start engages.
(See the Feature Descriptions section in this guide for details about programming
this output.)
28
TACHOMETER INPUT
(+) BRAKE SWITCH INPUT
(-) HOOD PIN SWITCH INPUT, ZONE 6
(-) 200mA STATUS OUTPUT / REAR DEFOGGER
© 2009 Directed Electronics. All rights reserved.
Tach Learning