Python 513 Installation Manual page 51

2-10 FACTORY ALARM DISARM—WITH UNLOCK(1), BEFORE UNLOCK(2),
REMOTE START ONLY(3): In the default setting the factory alarm disarm output
disarms the factory alarm anytime the Unlock button is pressed. The BEFORE
UNLOCK output disarms the factory alarm before the unlock output activates
and before remote start is activated. The REMOTE START ONLY output disarms
the factory alarm only before the remote start is activated.
2-11 FACTORY ALARM DISARM PULSES—SINGLE, DOUBLE: Selectable for a
single or double-pulse for the vehicle's factory alarm disarm input requirements.
2-12 AUX 2 VALIDITY(1)/LATCHED (2)/LATCHED RESET WITH IGNITION(3)
/30(4), 60(5) and 90(6) SEC TIMED OUTPUT: This wire provides a (-) 200mA
output whenever the transmitter buttons controlling AUX 2 are pressed. This out-
put can be programmed to provide the following outputs:
• Validity: Output sends a signal as long as the transmission is received.
• Latched: Output sends a signal when the AUX button is pressed, and will
continue until the same combination of buttons are pressed again.
• Latched, reset with ignition: Similar to the latched output, this output turns
on the first time the AUX button is pressed, and turns off the next time the
same combination of buttons are pressed. Additionally the output stops
and resets whenever the ignition is turned On and then Off.
• 30-second timed: Output sends a continuous signal for 30 seconds.
Note: All auxiliary channel timed outputs can be programmed using the
Bitwriter (1-90 seconds).
2-13 AUX 2 LINKING NONE (1)/ARM (2), DISARM (3), REMOTE START(4):
When programming to validity or timed output this can be programmed to acti-
vate when arming or disarming (or remote starting) with the transmitter.
2-14 AUX 3 VALIDITY(1)/LATCHED(2)/LATCH RESET WITH IGNITION
(3)/30(4), 60(5), 90(6) SEC TIMED OUTPUT: AUX 3 can be programmed
for these output configurations. The unit is set to the default validity output. To
change the configuration, use the two-chirp setting to toggle through the different
configurations. Refer to feature 2-12 for additional detail.
2-15 AUX 3 LINKING NONE (1)/ARM(2), DISARM(3), REMOTE START(4):
Refer to feature 2-13 for additional detail.
© 2009 Directed Electronics. All rights reserved.
51