Python 513 Installation Manual page 61

• The vehicle starts, but immediately dies.
1. Does the vehicle have an immobilizer? The vehicle's immobilizer will cut the
fuel and/or spark during unauthorized starting attempts.
2. Is the remote start programmed for voltage sense? If so, the crank time may
not be set high enough. Voltage sense will not work on some vehicles.
3. Check diagnostics. Sometimes a shutdown will become active during
cranking or just after cranking.
• The vehicle starts, but the starter keeps running.
1. Is the system programmed for engine checking off or voltage sense? When
programmed for either of these features, the engine cranks for the pre
programmed crank time regardless of how long it takes for the vehicle to
actually start. Adjust to a lower cranking time.
2. Was the Tach Learn successful? The LED must light solid and bright to
indicate a successful learn.
3. Make sure that there is a tach signal at the purple/white tach input wire
of the remote start. If there is not a tach signal, recheck the connection to
the vehicle's tach wire and make sure the wire is not broken or shorted to
ground leading to the remote start.
• The vehicle starts, but will only run for 10 seconds.
1. Is the remote start programmed for voltage sense? If this does not work, a
tach wire should be used.
2. Check shutdown diagnostics.
• The climate control system does not work while the unit is operating the
vehicle.
Either the wrong accessory wire is being energized or more than one igni-
tion or accessory wire must be energized in order to operate the climate
control system.
© 2009 Directed Electronics. All rights reserved.
61