Shock Sensor Harness, 4-Pin White Plug - Python 680XP Installation Manual

3. Mount the receiver/antenna using the supplied double-sided tape.
4. Route the receiver/antenna cable to the control module and plug it into the four-pin antenna
connector.
IMPORTANT! To achieve the best possible range, DO NOT leave the antenna cable
bundled under the dash. Always extend the cable full length during installation,
regardless of the antenna mounting location.
TWO-WAY IN-VEHICLE
TRANSCEIVER CABLE

Shock Sensor Harness, 4-Pin White Plug

GREEN (-) Multiplex Input
Inputs shorter than 0.8 seconds will trigger the Warn Away® response, while inputs longer than 0.8
seconds will trigger full alarm sequence and report Zone 4.
NOTE: If installing an optional Directed dual-stage sensor, connect to the GREEN wire. The
following diagram eliminates the need for diodes to isolate the sensors, as well as providing a
separate zone for each sensor.
Diagram for adding optional Directed dual stage sensor to GREEN wire (zone 4).
12
TWO-WAY IN-VEHICLE
CONTROL
MODULE
TRANSCEIVER
DRW-365
© 2004
Directed Electronics, Inc.