Python 513 Installation Manual page 19

H1/9 BLACK/WHITE
Connect this wire to the optional dome light supervision relay as shown below:
Important! This output is only intended to drive a relay. It cannot be connected
directly to the dome light circuit, as the output cannot support the current draw
of one or more light bulbs.
H1/9 BLACK/WHITE
H1/10 WHITE/BLUE
This input comes from the factory set to 1 activation pulse. This means that it is
necessary to have a single pulse on the white/blue wire for the remote start to
activate or to deactivate. The same holds true for the remote control activation
it is necessary to press the
deactivate.
:
Note
The number of activation inputs can be programmed to 1 or 2 pulses with
an optional momentary switch. This setting affects both the input wire and the
remote control when operating the remote starter.
© 2009 Directed Electronics. All rights reserved.
(-) 200mA DOME LIGHT OUTPUT SUPERVISION OUTPUT
(-) REMOTE START ACTIVATION INPUT
button once for the remote start to activate or
To white/blue activation
input on system
19