Step 8 - Pedal Assembly - Smooth Fitness VT-3.4 Owner's Manual

"A
I
SSEMBLY NSTRUCTIONS"
FIG. 2
Bolt (M8xp1.25x65mm)(105), 1pc Nylon Nut (M8xp1.25)(112) from the Right Roller Bracket (69).
d. Refer to FIG 3. Place the Right Pedal Support Arm (14) onto the Right Sliding Rail (5) Lining up the
groove of the Pedal Support Arm Roller with the Sliding Rail.
e. Then place the Roller Spacer (56) through the Roller Bracket (69) and under the Right Sliding Rail (5),
secure the 1pcs Bolt (M8xp1.25x65mm)(105) through the Roller Spacer (56) with the1pcs Nylon Nut
(M8xp1.25)(112). NOTE: Please be sure not to over-tighten the Bolt (105) and Nut (112), after tightening,
make sure the Roller Spacer (56) will still rotate slightly. Use your finger to rotate the Roller Spacer (56).
If the Roller Spacer (56) is unable to rotate, it may cause the roller to run roughly on the Sliding Rail.
Loosen the nut and bolt slightly if necessary.
f. Repeat the process above for the left side.
S –
TEP 8 Pedal Assembly
a. Attach the Pedal Bottom Cover (130) to the Right Pedal (54) and secure it with the 3pcs Flat Head Self-Tapping
Screws (M4x10mm) (131).
b. Attach the Right Pedal (54) to the upper Pedal Plate located on the rear of the Right Pedal Support Arm (14) and
secure it with the 2pcs Lock Washers (M8)(79) and 2 pcs Bolts (M8xp1.25x16mm)(94).
c. Repeat the process above for the left side.
FIG. 3
9
S –
TEP 7 Pedal Support Arm
Assembly
a. Refer to the inset drawing FIG .2: Cut off
the tie wrap (A) on the front end of the
Right Pedal Support Arm (14). NOTE:
Please be sure that the Shaft Sleeve (68)
inside the Pedal Support Arm (14) does
not fall out while cutting off the tie.
b. Attach the front end of the Right Pedal
Support Arm Assembly (14) to the Right
Pivoting Arm (12) with the 1pc Bolt
(M8xp1.25x90mm)(106) and 1pc Nut
(M8xp1.25)(112) NOTE: Confirm that Bolt
(106) will slide through the Shaft Sleeve
(68) inside front end of the Right Pedal
Support Arm Assembly (14) during
assembly.
NOTE: Refer to the
inset drawing FIG.3:
For shipping
purposes, the1pc
Roller Spacer (56),
1pc Bolt
(M8xp1.25x65mm)
(105), 1pc Nylon Nut (M8xp1.25)(112) are
preinstalled on the Right Roller Bracket (69)
as pictured on the right.
c. Remove the 1pc Roller Spacer (56), 1pc