Step 13 - Ac Adaptor - Smooth Fitness VT-3.4 Owner's Manual

"A
I
SSEMBLY NSTRUCTIONS"
b. Slide the Right Handlebar Sleeve (44) onto the Right Upper Handlebar (9).
c. Insert the Right Upper Handlebar (9) into the Right Middle Handlebar (11) and secure it with the 2 Bolts
(M6xp1.0x35mm)(99) and 2pcs Nylon Nuts (M6xp1.0)(110).
d. Slide the Right Handlebar Sleeve (44) down until it touches the middle part of Handlebar.
e. Repeat the process above for the left side.
f. The assembly process is complete
g. Check that all parts in the assembly directions are fully tightened before you use the equipment.
S –
TEP 13 AC Adaptor
a. Connect the Adaptor to the connector located on the front end of the Main
Frame (1).
b. Plug the Adaptor into an electrical outlet to power up your Vertical Trainer.
11
S –
TEP 12 Console
Cover, Handlebar Sleeve
& Upper Handlebar
Assembly
a. Attach the Right Console
Cover (35) and the Left
Console Cover (34) around the
Upright Post Assembly (6).
Bolt the Console Covers
together (34, 35) by using the
4pcs Bolts
(M5xp0.8x15mm)(91).
NOTE: Make sure that the Right
Console Cover (35) and the Left
Console Cover (34) cover the
Upright Cover and the lowest layer
of the Console Bottom Sleeve (33)
as the following illustration shown.
Bottom
Console
Sleeve