Network Problem; Installation Problem - Brother MFC-8220 Service Manual

10.

NETWORK PROBLEM

If the error related to network occurs, refer to the following sections;
10.1

Installation Problem

If you cannot print over the network, check the following:
(1) Make sure that the machine is powered on, is on-line and ready to print.
Verify that the machine and the configuration are good by printing the machine settings
page. If the test fails, check:
a) If the LED is not blinking after connected to the network, then the network firmware
settings may be corrupted. Please refer to
b) In this event, try to restore the factory default settings of the print/fax server. To learn
how to reset the print server, set APIPA to off using control panel. Once you have done
that, switch the machine off and then on again, and try to print out the configuration
page.
(2) If the configuration page is prints but you cannot print documents, try the following.
NOTE:
If none of the following steps are successful, there is almost certainly a hardware or
network problem!
a) If you are using TCP/IP:
Try pinging the print/fax server from the host operating system command prompt with
the command:
ping ipaddress
Where ipaddress is the print/fax server IP address (note that in some instances it can
take up to two minutes for the print/fax server to load its IP address after setting the IP
address). If a successful response is received, then proceed to the UNIX, TCP/IP
Windows
or Web Browser troubleshooting section. Otherwise, proceed to
to subsection 10.3 'TCP/IP
b) If you are using Novell system:
Verify that the machine server can be seen on the network. To do this, login as the
SUPERVISOR (not as someone with supervisor privileges) or ADMIN (for Netware 4
or later servers), go into PCONSOLE or NWADMIN, select PRINT/FAX SERVER
INFORMATION, and select the name of the print/fax server (make sure that you have
entered the print/fax server name). If you can see Print/Fax Server Status and Control
in the menu, then the Brother print/fax server is visible to the network, proceed to
subsection 10.11 'Novell NetWare
c) If you are running AppleTalk for Macintosh:
In case of using Postscript driver make sure that you can see the print/fax server name
under the LaserWriter 8 icon in the Chooser. If it is visible, then the connection is
good, so proceed to
step (3).
If you use the Rendevous function, please visit the Brother Solution Center web site
on: http://solutions.brother.com
®
NT/LAN Server, Windows
Troubleshooting'.
subsection 10.12 'AppleTalk
step (3).
®
98/95/Me Peer to Peer (LPR), Internet Printing
Troubleshooting'. Otherwise, go to
Troubleshooting'. Otherwise, go to
6-53
MFC-8220
SERVICE MANUAL
step (3), and then go
step (3).