Paper Problems; Paper Loading Problems - Brother MFC-8220 Service Manual

CHAPTER 6 TROUBLESHOOTING
3.

PAPER PROBLEMS

3.1

Paper Loading Problems

First, make sure that you are using paper that meets Brother recommended paper
specifications.
The machine does not feed
paper.
The machine does not feed
paper from the manual feed
tray.
The machine will not feed
envelopes.
A paper jam has occurred.
The machine does not print
into the top output tray.
The machine does not feed
paper from the lower tray
properly.
(Only when the lower tray,
which is optional, is used.)
The "Check original" message
is displayed although a
document is set.
Document not fed.
Document double feeding.
Document jam.
See 2.3 "Paper" in Chapter 1.
Problem
• If there is paper in the paper tray, make sure it is straight. If
• Reduce the amount of paper in the paper tray, and then try
• Check that manual feed tray is not selected in the printer
• Re-insert the paper firmly, one sheet at a time.
• Make sure that manual feed tray is selected in the printer
• The machine can feed envelopes from the manual feed
• Clear the jammed paper. Please refer to QSG.
• Close the back output tray.
• Check if the lower tray is correctly connected to the
• Check if an appropriate tray is selected by the printer driver.
• Check the sensors by using the maintenance mode
• Check the document front sensor actuator and document
• Check the main PCB.
• Check the ADF and its related sections.
• Check the ADF motor and its harness.
• Check the document feed roller and its related gears.
• Check the main PCB.
• Check the ADF parts.
• Check the ADF motor.
the paper is curled, you should straighten it before printing.
Sometimes it is helpful to remove the paper, turn the stack
over and put it back in the paper tray.
again.
driver.
driver.
tray. Your application software must be set up correctly to
print on the envelope size you are using. This is usually
done in the page setup or document setup menu of your
software. Please see your software application manual.
machine.
function code 32. (Refer to Chapter 7, Subsection 3.9)
rear sensor actuator.
6-10
Remedy