Wsw23 - Brother MFC-8220 Service Manual

APPENDIX 3 FIRMWARE SWITCHS (WSW)
Selector
No.
1
2
3
4
5
6
7
8
NOTE:
Selector 8 is not applicable to the French versions.
l Selector 1:
At the training phase of receiving operation, the called station detects for 1.0 second a
training check (TCF) command, a series of zeros which is sent from the calling station for 1.5
seconds to verify training and give the first indication of the acceptability of the line.
This selector sets the starting point from which the called station should start counting those
zeros. If this selector is set to "0," the called station starts counting zeros 100 ms after the
head of a series of zeros is detected.
If it is set to "1," the called station starts counting zeros upon detection of 10-ms successive
zeros 50 ms after the head of a series of zeros is detected. In this case, if the detection of
10-ms successive zeros is too late, the data counting period will become less than 1.0
second, making the called station judge the line condition unacceptable.
l Selectors 2 and 3: Allowable training error rate
The called station checks a series of zeros gathered in training (as described in Selector 1)
according to the allowable training error rate set by these selectors. If the called station
judges the line condition to be accepted, it responds with CFR; if not, it responds with FTT.
l
Selectors 4 and 5: Decoding error rate for transmission of RTN
The machine checks the actual decoding errors and then transmits an RTN according to the
decoding error rate (Number of lines containing an error per page ÷ Total number of lines per
page) set by these selectors.
l Selector 8:
Setting this selector to "0" limits the transmitting level of the modem to 10 dB.
This setting has priority over the settings selected by WSW02 (selectors 5 through 8) and
WSW13 (selectors 5 through 8).
WSW23 (Communications setting)
Function
Starting point of training check
(TCF)
Allowable training error rate
Decoding error rate for
transmission of RTN
Not used.
Limitation of attenuation level
Starting point of training check (TCF)
Limitation of attenuation level
Setting and Specifications
0: From the head of a series of zeros
1: From any arbitrary point
No. 2 3
0 0
0 1
1 0
1 1
No. 4 5
0 0
0 1
1 0
1 1
0: Yes
A-28
: 0%
: 0.5%
: 1%
: 2%
: 16%
: 14%
: 10%
: 8%
1: No