Brother MFC-8220 Service Manual page 129

(3) Remove the two bind B M4x12 Taptite screws, and then remove the inlet holder.
(4) Remove the bind B M4x12 Taptite screw, and then remove the SW holder.
(5) Remove the fan motor 60 unit.
(6) Remove the low-voltage PS PCB.
Inlet holder
Taptite, bind B
M4x12
SW holder
Taptite, bind B M4x12
Hint: Inlet Harness Installation Procedure
Mount the inlet.
Mount the fan motor 60 unit.
Pull the inlet harness behind the fan motor 60 unit to the side of the SW holder to take up
the slack. (Important!)
Mount the SW holder.
Low-voltage PS PCB
Inlet
Fig. 4-92
4-51
MFC-8220
SERVICE MANUAL
Fan motor 60 unit