Brother MFC-8220 Service Manual page 122

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
NOTE:
When re-assembling the paper eject actuator and the eject actuator spring to the FU frame
lower, ensure the paper eject actuator is seated correctly in the locating channel referring to
the figure below;
(28) Disconnect the heater harness.
(29) Remove the four cup B M3x6 Taptite screws.
(30) Remove the four separate claw holder plate.
(31) Remove the four separate claw ASSY.
Separate claw holder plate
Separate claw ASSY
Heater harness
Paper eject actuator
Fig. 4-79
Fig. 4-80
4-44
FU frame lower
Eject actuator spring
Taptite, cup B M3x6
Separate claw ASSY
Tweezers